LCP 130° DHS, SHORT BARREL
Dynamic Hip Screw Plate
Specification
- Plates are made of 316L stainless steel and Titanium.
- The Dynamic Hip Screw Plate are available in a wide range of sizes (3 to 16 holes) and barrel angles (130 degree, 135 degree, 140 degree, 145 degree), with 38 mm (standard) or 25 mm (short) barrels, for varied clinical situations.
- The number of screw holes per plate length is maximized, without compromising plate strength. This allows an increased number of fixation points with a smaller incision.
- Dynamic compression plate holes in the Plate side plate allow angulation of 4.5 mm cortex screws, for lag screw fixation of medial fragments, and allow axial compression and multiple-screw fixation of the main fragment in subtrochanteric fractures with shaft extension.
- Two flats within the plate barrel correspond to the two-flat design of the Dynamic Hip Screw Plate lag screw, preventing rotation of the lag screw within the barrel. The two-flat design also eases insertion of the plate over the lag screw.
Uses
This Plate has a low-profile design, reducing the risk of trochanteric bursitis